INSTRUMENTATION EQUIPMENT
2.0 INTRODUCTION
Instrumentation is the art of measuring the value of some plant parameter,
pressure, flow, level or temperature to name a few and supplying a signal
that is proportional to the measured parameter. The output signals are
standard signal and can then be processed by other equipment to provide
indication, alarms or automatic control. There are a number of standard
signals; however, those most common in a CANDU plant are the 4-20 mA
electronic signal and the 20-100 kPa pneumatic signal.
This section of the course is going to deal with the instrumentation
equipment normal used to measure and provide signals. We will look at
the measurement of five parameters: pressure, flow, level, temperature,
and neutron flux.
2.1 PRESSURE MEASUREMENT
This module will examine the theory and operation of pressure detectors
(bourdon tubes, diaphragms, bellows, forced balance and variable
capacitance). It also covers the variables of an operating environment
(pressure, temperature) and the possible modes of failure.
2.1.1 General Theory
Pressure is probably one of the most commonly measured variables in the
power plant. It includes the measurement of steam pressure; feed water
pressure, condenser pressure, lubricating oil pressure and many more.
Pressure is actually the measurement of force acting on area of surface.
We could represent this as:
Pressure Force
Area
P F
or A
The units of measurement are either in pounds per square inch (PSI) in
British units or Pascals (Pa) in metric. As one PSI is approximately 7000
Pa, we often use kPa and MPa as units of pressure.
2.1.2 Pressure Scales
Before we go into how pressure is sensed and measured, we have to
establish a set of ground rules. Pressure varies depending on altitude above
sea level, weather pressure fronts and other conditions.
The measure of pressure is, therefore, relative and pressure measurements
are stated as either gauge or absolute.