Or, wrong Correct the tape, or select proper format. Reader does not Check connection of reader cable. Move the frame to its working area. Check needle position card, BP card. Check for a mechanical bind in the color change system. Check for a mechanical bind in the color change system. Return the main shaft to the fixed position. Check the encoder signal Main shaft Z signal 212 Needle bar is in lowering position Move up the needle bar by needle bar operation. Turn on power again, if error 234 remains check the laser unit. Add oil to the lubrication tank. Correct display, action complete. Same + and Correct the design data 2B3 Data exists in an end code Correct the design data 2B4 Code format error A stitch code does not Correct the design data exist at the third character. During frame forward operation: Wait until all of the design data is read. Complete initial setting of laser power. Check the rotary encoder and encoder the fabric wiring. If problem continues install software version BD or later. If problem persists, change IMM card. LG 342 An M-axis PMD abnormal signal is detected. Check the mechanical parts related to the M-axis for abnormalities. After adjustment, reset the signal machine. After adjustment, press the RESET key. LG be input 372 ZB Signal error CE 372 The nipples do not move more than 1 second Press the RESET key. Then change the nipple stroke by using the keys from 1 to 5. If code 383 is still displayed, replace CE the head card of the corresponding CE head. If code 384 is still displayed, replace CE motor the head card of the corresponding CE head. Check thread holding inverter LED. If re LED is lit, change the inverter. If not, check the harness. If code 3C1 is still displayed, check the machine has been stopped by keeping the bar switch and the switch harness. Check settings, parameters IDM Card, and design settings. Check master card CE 3D2 There is abnormality in a battery backup signal Charge the battery by turning on the power of the machine. Check settings, parameters IMM Card, and design settings. B02 Floppy disk management information Copy data of the floppy disk to a new floppy disk and dispose of the old floppy disk. If there is no problem with the connection then replace the FDD unit. CE1 Communication speed set for the external de- Check the communication speed setting. Temporary Stops 1B1 Stop due to frame stepping code These stop codes are not caused by abnormality or failure. After One drop of oil lubrication, press the stop button to release the maintenance mode to continue working As per Inst. CAUTION: Grease Cams When this messsage is displyed on the screen, grease the specified spots p. After Take-up, Presser greasing, press the stop button to release the maintenance mode to continue working As per Inst. CAUTION: Grease Cams When this messsage is displyed on the screen, grease the specified spots p. After Take-up, Presser, Trim greasing, press the stop button to release the maintenance mode to continue working Needle Case Drive for 3D7 TMEG error RPM ADJUSTMENT 1. DSW 2-7: ON 2. Turn on the power. Set any design data to run the machine keeping high speed. Set the machine speed at 850rpm and turn off the head switch so the machine runs without sewing. Press F7: RPM Adj. Stop the machine is speed becomes 250 rpm. Turn off the power and DSW 2-7 : OFF for 3D7 TMEG error RPM ADJUSTMENT 1. DSW 2-7: ON 2. Turn on the power. Set any design data to run the machine keeping high speed. Set the machine speed at 850rpm and turn off the head switch so the machine runs without sewing. Press F7: RPM Adj. Stop the machine is speed becomes 250 rpm. Turn off the power and DSW 2-7 : OFF.
